Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice A/D User Guide Simulation examples October 2019 82 Product Version 17.4-2019 © 2022 All Rights Reserved. To assign names (labels) to the nets 1. Choose Place – Net Alias to display the Place Net Alias dialog box. You can also click the Net Alias button ( ). 2. In the Name text box, type Mid. 3. Click OK. 4. Place the net alias on any segment of the wire that connects R1, R2, R3, the diodes, and the capacitor. The lower left corner of the net alias must touch the wire. 5. Right-click and choose End Mode to quit the Net Alias function. Tip It is recommended that special characters should not be used for naming nets, nodes, projects, or libraries. While naming nets, characters such as ? (question mark), @ (at symbol), ~ (telda), #(hash), & (ampersand), %(percent sign), and " (quotation marks) should not be used. These might cause the netlister to fail. Other special characters such as ! (exclamation mark), ( )(parenthesis), < (smaller than), = (equal), > (greater than), [ ](square parenthesis), and * (asterix) are also considered as illegal for naming nets. To assign names (labels) to the off-page connectors Label the off-page connectors as shown in Figure 2-1 on page 76. 1. Double-click the name of an off-page connector to display the Display Properties dialog box. 2. In the Name text box, type the new name. 3. Click OK. 4. Select and relocate the new name as desired. To assign names to the parts 1. Double-click the second VDC part to display the Parts spreadsheet.