Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide Bias Point Display October 2019 827 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. Toggling a specific current bias display To turn on the display of a specific current bias point: 1. In Capture, from the Edit menu, choose Select All. 2. Click the Toggle Selected Bias Current button in the Bias Point toolbar ( ). This will either turn off all current bias values for every pin on the schematic page, or they will all be turned on, depending on the previous state. Click the button again, if necessary, to turn everything off. If there is no change in the display either way, be sure that Enable Bias Current Display is checked. 3. Click the mouse on an empty area of the schematic page to deselect everything. 4. Click the specific pin you want to display the current on, in order to select it. 5. Click the Toggle Selected Bias Current button in the Bias Point toolbar ( ). You should now see only the current bias point value for the specific pin you are interested in. All other current bias points on the schematic page should be turned off. Toggling a specific voltage bias display To turn on the display of a specific voltage bias point: 1. In Capture, from the Edit menu, choose Select All. 2. Click the Toggle Selected Bias Voltage button in the Bias Point toolbar ( ) This will either turn off all voltage bias values for every net on the schematic page, or they will all be turned on, depending on the previous state. Click the button again, if necessary, to turn everything off. If there is no change in the display either way, be sure that Enable Bias Voltage Display is checked. 3. Click the mouse on an empty area of the schematic page to deselect everything. 4. Click the specific net you want to display the voltage on, in order to select it. 5. Click the Toggle Selected Bias Voltage button in the Bias Point toolbar ( ). You should now see only the voltage bias point value for the specific pin you are interested in. All other voltage bias points on the schematic page should be turned off.