PSpice User Guide

PSpice User Guide

Issue link: https://resources.pcb.cadence.com/i/1180526

Contents of this Issue

Navigation

Page 80 of 896

PSpice A/D User Guide Simulation examples October 2019 81 Product Version 17.4-2019 © 2022 All Rights Reserved. To connect the parts 1. From the Place menu, choose Wire to begin wiring parts. The pointer changes to a crosshair. 2. Click the connection point (the very end) of the pin on the off-page connector at the input of the circuit. 3. Click the nearest connection point of the input resistor R1. To stop wiring, right-click and choose End Wire. The pointer changes to the default arrow. Clicking on any valid connection point ends a wire. A valid connection point is shown as a box (see Figure 2-4). Figure 2-4 Connection Points If you make a mistake when placing or connecting components: From the Edit menu, choose Undo, or click . 4. Connect the other end of R1 to the output capacitor. 5. Connect the diodes to each other and to the wire between them: a. Click the connection point of the cathode for the lower diode. b. Move the cursor straight up and click the wire between the diodes. The wire ends, and the junction of the wire segments becomes visible. c. Click again on the junction to continue wiring. d. Click the end of the upper diode's anode pin. 6. Continue connecting parts until the circuit is wired as shown in Figure 2-1 on page 76. Figure 2-3 Connection points.

Articles in this issue

view archives of PSpice User Guide - PSpice User Guide