Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide Bias Point Display October 2019 824 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. Moving bias points Bias points have a default position near their corresponding wire or pin. You can select the bias point labels and relocate them to make the schematic page more legible. A dashed leader line extends from the label to the wire or pin it is associated with to indicate where the label belongs. To move a bias point label: 1. Click on the label you wish to move to select it. 2. While holding down the left mouse button, drag the label to the new location. Once you move a label, the new location will be saved with the schematic page so the bias point will be displayed there again the next time you open that page. Updating bias point values The bias point values displayed in Capture reflect the data from the last simulation that was performed in PSpice. In some cases, these may not be the most recent values, depending on when they were last updated. There are three ways to update the values. To update the bias point values by resimulating: ➤ In Capture, from the PSpice menu, choose Run. By re-running the simulation in PSpice, you update the bias points to the correct values. To update the bias point values by changing profiles: 1. In Capture's Project Manager, under the File tab, double-click on the Simulation Profiles folder to see all the defined profiles for this project. 2. Right-click on the profile you want to make active. A shortcut menu appears. 3. From the shortcut menu, select Make Active. By opening a new simulation profile, you update the bias points to reflect the correct values that were last calculated for that profile.