PSpice User Guide
Setting up analyses and starting simulation
October 2019 423 Product Version 17.4-2019
© 1999-2019 All Rights Reserved.
schematic page is referred to as Y1.R34 when used in an output
variable.
A (from line 4) is uniquely distinguished by specifying the full
part name (as described above) followed by a colon, and the pin
name. For example, the pins on a capacitor with reference designator
C31 placed on a top-level page and pin names 1 and 2 would be
identified as C31:1 and C31:2, respectively.
Current
Specify current in the following format:
i[modifiers]([:modifiers])
where is a fully qualified device name.
Modifiers
The basic syntax for output variables can be modified to indicate
terminals of semiconductors and AC specifications. The modifiers
come before or . Or, when specifying
terminals (such as source or drain), the modifier is the pin name
contained in , or is appended to separated by
a colon.
Modifiers can be specified as follows:
■ For voltage:
v[AC suffix]([, out id])
v[terminal]*()
■ For current:
i[AC suffix]([:terminal])
i[terminal][AC suffix](])
where
terminal specifies one or two terminals for
devices with more than two terminals,
such as D (drain), G (gate), S (source)
