Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide
Digital simulation
October 2019 612 Product Version 17.4-2019
© 1999-2019 All Rights Reserved.
To introduce transitions (method one)
1. From the Plot menu, choose Axis Settings.
2. Enter values in the Displayed Range for Time text boxes and the
Timing Resolution text box as required for adding transitions.
For example, if you wish to add transitions every 1 ms, set the
Timing Resolution to 1ms.
3. From the Stimulus Editor's Edit menu, choose Add.
4. In the digital value field on the toolbar (just right of the Add
button), type a bus value in any of the following ways:
If you do not enter a radix value, the Stimulus Editor appends the
default bus radix. To find out about valid radix values, see
page 14-11.
5. Click the waveform where you want the transition added.
6. Repeat steps 4
and 5 as needed.
7. When you finish, right-click to exit the editing mode.
Table 14-4
To get this
effect...
Type this...
A literal value