Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice A/D User Guide Simulation examples October 2019 90 Product Version 17.4-2019 © 2022 All Rights Reserved. 6. Right-click and choose Done to stop placing parts. For each instance of a part you place, Design Entry HDL automatically assigns a PATH property. This property has a unique value that helps identify the instance. Values are I1, I2, I3....In. To place the other parts 1. Choose Component – Add, if needed. Component Browser appears. 2. Select analog from the Library list. 3. Follow similar steps as described for the diodes to place the parts listed below, as in shown in Figure 2-1 on page 76. The part names you need to select in the Cells list box of Component Browser are shown in parentheses: ❑ resistors (R) ❑ capacitor (C) 4. Select source from the Library list in the Component Browser. 5. Select 0 in the Cells list box and place the ground part (0) as shown in Figure 2-5 on page 85. Important You must use the 0 (zero) ground part from the SOURCE library. You can use any other ground part only if you change its name to 0 (zero). To connect the parts 1. Choose Wire – Draw to begin wiring parts. The pointer changes to a crosshair. 2. Click the connection point (the very end) of the pin on Vin (the VDC part at the input of the design). 3. Click the nearest connection point of the input resistor R1. 4. Connect the other end of R1 to the output capacitor. 5. Connect the diodes to each other and to the wire between them: