Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide Analyzing waveforms October 2019 717 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. To load and display the data file, you can either select the Use fewer data points to display complete trace option or the Use all data points to display trace in parts option. To load the complete data file, select the Ignore this warning option. When you select this option, the data file may or may not get loaded depending on your system memory. For example, on some machines a data file with 5 million data points may open without any problems while on some other machine the same data file might be too large to be loaded in one go. To make your selection the default setting, select the Always use this option check box. Once this check box is selected, next time when you try to open a large data file, the Large Data File dialog box does not appear. Instead, the option selected by you previously is used to open the large data file. The following two options are disabled for marching waveforms: ■ Use fewer data points to display complete trace ■ Use all data points to display trace in parts Switching Modes While viewing the trace from a large data file, you can switch from one mode to another using one of the following methods. ■ Using the View drop-down menu a. From the View menu in PSpice select Large Data File Mode. b. In the Large Data File Mode submenu, select the mode in which you want to view the trace. The mode currently selected, has a check mark against it. ❍ Select Display Fewer Data Points when you want to view the complete trace that may not be very accurate.