Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide Monte Carlo and sensitivity (worst-case) analyses October 2019 574 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. name by double-clicking the part and typing Meter in the Reference cell in the Parts Spreadsheet. ■ For R1-R7, place a resistor using the R part. ■ Place the analog ground using the 0 ground symbol from the SOURCE.OLB part library. ■ To connect the parts, from the Place menu, choose Wire. ■ To move values or reference designators, click the value or reference designator to select it, then drag it to the new location. Defining part values Define the part values as shown in Figure 13-5 on page 573. For the pressure sensor, you need to do the following: ■ Change the resistor values for R3, R5, R6, and R7 from their default value of 1 k. ■ Set the DC value for the V1 voltage source. Note: Because the Meter source is used to measure current, it has no DC value and can be left unchanged. To change resistor values 1. Double-click the value for a resistor.