Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide Creating parts for models October 2019 310 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. PSPICETEMPLATE The PSPICETEMPLATE property defines the PSpice syntax for the part's netlist entry. When creating a netlist, the design entry tool substitutes actual values from the circuit into the appropriate places in the PSPICETEMPLATE syntax, then saves the translated statement to the netlist file. Caution The PSPICETEMPLATE property is required only for models based on device characteristic curves. For template-based models, netlisting is done using the PORT_ORDER information available in the device property file. Note: The PSPICETEMPLATE property is not required with template-based models. Therefore, while modifying a design, if you attach a template-based model to a part originally attached to a characteristic curve based model, then besides changing the Implementation property, you must also delete the PSPICETEMPLATE property. Any part that you want to simulate must have a defined PSPICETEMPLATE property. These rules apply: ■ The pin names specified in the PSPICETEMPLATE property must match the pin names on the part. ■ The number and order of the pins listed in the PSPICETEMPLATE property must match those for the associated .MODEL or .SUBCKT definition referenced for simulation. PSPICEDEFAULTNET PSPICEDEFAULTNET on page 320 Table 5-3 To find out more about this property... See this...