Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide DC analyses October 2019 482 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. Bias point Minimum requirements to run a bias point analysis Minimum circuit design requirements None. Minimum program setup requirements 1. Under Analysis type in the Simulation Settings dialog box, select Bias Point. 2. For the General Settings option, enter the necessary parameter values and select the appropriate check boxes to complete the analysis specifications. 3. Click OK to save the simulation profile. 4. In Capture, from the PSpice menu, select Run to start the simulation. Overview of bias point The bias point is calculated for any analysis whether or not the Bias Point analysis is enabled in the Simulation Settings dialog box. However, additional information is reported when the Bias Point analysis is enabled. Also see Save and load bias point on page 830. When Bias Point analysis is not enabled, only analog node voltages and digital node states are reported to the output file. When the Bias Point analysis is enabled, the following information is reported to the output file: ■ a list of all analog node voltages ■ a list of all digital node states ■ the currents of all voltage sources and their total power ■ a list of the small-signal parameters for all devices