Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide DC analyses October 2019 476 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. Setting up a DC stimulus To run a DC sweep or small-signal DC transfer analysis, you need to place and connect one or more independent sources and then set the DC voltage or current level for each source. To set up a DC stimulus 1. Place and connect one of these symbols in your schematic: 2. Double-click the symbol instance to display the Parts spreadsheet appears. 3. Click in the cell under the DC column to edit its value. Table 9-1 For voltage input Use this... When you are running... VDC A DC Sweep and/or Bias Point (transfer function) analysis only. VSRC Multiple analysis types including DC Sweep and/or Bias Point (transfer function). Table 9-2 For current input Use this... When you are running... IDC A DC Sweep and/or Bias Point (transfer function) analysis only. ISRC Multiple analysis types including DC Sweep and/or Bias Point (transfer function).