Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide October 2019 275 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. 5 Creating parts for models Chapter overview This chapter provides information about creating parts for model definitions, so you can simulate the model from your design using the design entry tools 1 , OrCAD Capture or Design Entry HDL. For general information about creating parts, refer to the Capture User Guide or Design Entry HDL User Guide. Topics are grouped into four areas introduced later in this overview. If you want to find out quickly which tools to use to complete a given task and how to start, then: 1. Go to the roadmap in Ways to create parts for models on page 277. 2. Find the task you want to complete. 3. Go to the sections referenced for that task for more information about how to proceed. Background information These sections provide background on the things you need to know and do to prepare for creating parts: ■ What's different about parts used for simulation? on page 276 ■ Preparing your models for part creation on page 279 1. In this guide, design entry tool is used for both OrCAD Capture and Design Entry HDL. Any differences between the two tools is mentioned, if necessary.