Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide Creating and editing models October 2019 257 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. Examples: Smoke Adding smoke information to the D1 diode model In this example, you will use the Model Editor to add smoke information to the D1 diode model used in the half-wave rectifier design explained previously in Example: Creating a PSpice model based on device characteristic curves on page 219. To add smoke information, complete the following steps. 1. From the Model menu, choose Add Smoke. The Test Node Mapping and Smoke Parameters frames appear. Note: The Add Smoke command is enabled only if you have Advanced Analysis installed. 2. In the Test Node Mapping frame, add the following information. You can get the port names by opening the symbol in the design entry tool. a. Select the part in the design entry tool. b. From the Edit menu, choose Part. c. The symbol view of the part displays. Double-click a pin. Node Port TERM_AN 1 NODE_AN 1 NODE_CAT 2