Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice A/D User Guide Creating and editing models October 2019 227 Product Version 17.4-2019 © 2022 All Rights Reserved. ❑ 0 analog ground from the SOURCE library. 4. From the Wire menu, choose Draw and draw the connections between parts as shown in Figure 4-5 on page 227. 5. From the File menu, choose Save. Note: If you were to simulate this design using a transient analysis, you would also need to set up a transient specification for V1; most likely, this would mean defining the VOFF (offset voltage), VAMPL (amplitude), and FREQ (frequency) properties for V1. For this tutorial, however, you will not perform a simulation, so you can skip this step. Using the Model Editor to edit the D1 diode model To create a new model and model library 1. Open the Model Editor. 2. From the File menu in the Model Editor, choose New. 3. From the Model menu, choose New. 4. In the New dialog box, do the following: a. In the Model Name text box, type DbreakX. b. Select Use Device Characteristic Curves. c. From the From Model list, select Diode. Figure 4-5 Design for a half-wave rectifier.