Issue link: https://resources.pcb.cadence.com/i/1180526
PSpice User Guide Preparing a design for simulation October 2019 138 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. When netlisting fails or the simulation does not start If you have problems starting the simulation, there may be problems with the design or with system resources. If there are problems with the design, PSpice 1 displays errors and warnings in the Simulation Output window. You can use the Simulation Output window to get more information quickly about the specific problem. To get online information about an error or warning shown in the Simulation Output window 1. Select the error or warning message. 2. Press F1. The following tables list the most commonly encountered problems and where to find out more about what to do. Things to check in your design 1. Depending on the license available, you will access either PSpice or PSpice Simulator. Make sure that... To find out more, see this... ■ The model libraries, stimulus files, and include files are configured. Configuring model libraries on page 244 ■ The parts you are using have models. Unmodeled parts on page 178 and Defining part properties needed for simulation on page 308 ■ You are not using unmodeled pins. Unmodeled pins on page 184 ■ You have defined the grounds. Missing ground on page 184 ■ Every analog net has a DC path to ground. Missing DC path to ground on page 185 ■ The part template is correct. Defining part properties needed for simulation on page 308 ■ Hierarchical parts, if used, are properly defined. OrCAD Capture User Guide