Issue link: https://resources.pcb.cadence.com/i/1532922
Design for Test f Outline f Mask and Silkscreen f Spacing f Probe Standard 3D Constraints Now it's not enough to just do 2D constraints. 3D is considered. f Component to Component f Component to Board f Component to Rigid-Flex f Component to Board Edge Properties We also have properties being held inside Constraint Manager that came over from the schematic, such as: Net f Electrical Properties ɢ Frequency ɢ Period ɢ Duty Cycle ɢ Jitter ɢ Cycle to Measure ɢ Offset ɢ Bit Pattern ɢ Enable highspeed adjacent layer Keep-outs f General Properties ɢ Voltage ɢ Weight ɢ Route (Priority vs. to Shape) f Route/Vias Keepout Exception Component f Component Properties ɢ General ɢ Thermal ɢ Swapping ɢ Reuse f Pin Properties ɢ General (Pinuse, Pin Delay, Shorting Net, Voltage Source Pin) ɢ Shapes ɢ Manufacturing 33 www.cadence.com OrCAD X Constraint Management Guide