Issue link: https://resources.pcb.cadence.com/i/1160462
Cadence Allegro and OrCAD 17.2-2016 Installation Guide for Windows Performing Silent Installations April 2016 67 Product Version 17.2-2016 © 1999-2018 All Rights Reserved. MODE Specify if you want to install all the products or a selected list of products. This variable is in the State section. To install all products, edit the file to MODE=COMPLETE. To install specific product, edit to MODE=CUSTOM. If you specify the value of MODE as CUSTOM, you need to modify the Features section. In the Features section of the template, remove the semicolon (;) from the lines that contain the product to be installed. For example, to install all Cadence Allegro products, remove the semicolon from the beginning of the line Feature7=Allegro Products, as shown below. [Features] ;Feature0=OrCAD Products ;Feature1=OrCAD Products\OrCAD Capture CIS ;Feature2=OrCAD Products\OrCAD PSpice Designer ;Feature3=OrCAD Products\OrCAD FPGA System Planner ;Feature4=OrCAD Products\OrCAD PCB Designer ;Feature5=OrCAD Products\OrCAD PCB SI ;Feature6=OrCAD Products\PSpice Feature7=Allegro Products UPDATE_CRSTAL Specify Y if you want to update Crystal Reports. If you install Capture CIS or Design Entry HDL CIS for the first time, the value for this variable should be Y. UPDATE_VC_REDIST Specify Y if you want to update Microsoft Visual C++ Redistributables. Note: Installed products might not run if UPDATE_VC_REDIST is set to N. CONFIGURE_FIREWALL Specify Y if you want to create firewall entries. ALWAYS_OVERWRITE Overwrites existing installation if set to Y, which is the default. IKNOWBEST Specify IKNOWBEST=YES if you do not want the installer to check disk space before installation. The valid values are YES and NO.