Creating and Applying Physical Constraint Sets within the Constraint Manager
This video will demonstrate how to create a physical constraint set and apply that physical constraint set to nets in a the design
Other content in this Stream
Auto-Route versus Auto-Interactive Routing--Which Is Better?
This article discusses the similarities and differences of auto-route versus auto-interactive routing and which type of routing would be best to use.
Hysteresis Loss in a Transformer and How It Affects AC Circuits
Hysteresis loss in a transformer produces heat and decreases power conversion efficiency. Read more to learn about hysteresis and other loss sources.
Using Current-Voltage Characteristics for Improved PCBA Design
By making good use of current-voltage characteristics, as we describe in this blog, you can design more reliable PCBAs.
Comparing SGMII vs. SerDes Trace Routing for Communications PCBs
When deciding to use SGMII vs. SerDes, you need to know what PCBA trace routing guidelines apply. In this blog, we tell you how and why.
NDR Drain Diffusion
Negative capacitance FETs can use NDR characteristics to reduce energy consumption.
PCBA Design Tips to Avoid Reflow-Induced Failure
Reflow-induced failure is often overlooked until the turnaround time and costs for your boards increases. In this blog, we show you how to avoid these issues.
Net Management for Power Routing
This article talks about the importance of net management for power routing on a printed circuit board and some methods for doing so.
Microprocessor vs. Integrated Circuit--What’s the Difference?
When talking about a microprocessor vs. integrated circuit, there are many important distinctions and design considerations you need to know to work with them.
Linear Power Supply vs. Switching Power Supply: Advantages and Disadvantages
A linear power supply is generally not as efficient as a switch-mode power supply (SMPS), but it does afford better performance.
Vertical Conductive Structures (VeCS) for PCB HD Trace Routing
This article is about Vertical Conductive Structures (VeCS) and how they are used to benefit high-density routing in a printed circuit board design.
SerDes in FPGA: Importance to Overall FPGA Performance and Functionality
SerDes in FPGA minimizes the number of input/output pins and connections while providing data transmission over a differential or single line.
AC-DC Power Supply Guidelines for Beginners
Here is a collection of AC-DC power supply guidelines to help you incorporate this essential technology into your circuit designs.
Fault Tree Analysis Structure for Electronics Manufacturing
Fault Tree Analysis (FTA) and Failure Mode Effects Analysis (FMEA) provide different perspectives regarding risk in critical electronic systems.
The Importance of Thermal Relief in Circuit Design and PCBA Functionality
The use of thermal relief in circuit design is critical to the design process and it affects performance, functionality, and lifecycle.
Implementing Lean Manufacturing
Implementing lean manufacturing eliminates waste and increases value.
How to Design Reliable Analog ASICs
Designing analog ASICs should be performed with the same objectives of operational and structural reliability as for PCBA design, as we explain in this blog.
Why and When Is Thermal Paste Needed for PCB Assembly?
Is thermal paste needed for your board’s assembly can be determined by following the checklist we provide in this blog.
32 Bit Microcontroller: A Beginner’s Guide
32 bit microcontrollers are powerful PCB components but aren’t for every application. Check out this article for a full explanation of design considerations.
The Use of the Phase Shift Formula in AC Circuit Analysis
The phase shift formula enables calculations that are vital to AC circuit analysis. Let’s look at the importance of these phase shift calculations.
Is Laminated Object Manufacturing the Future of Rapid PCB Prototyping?
Laminated object manufacturing is a type of 3D printing and is a great way to rapidly and cheaply produce single-layer PCB prototypes.