Best Practices: Working with Backdrilling

October 28, 2019 Cadence PCB Solutions

Backdrilling is a board fabrication process that removes the unused section of plated-through
holes; typically connector pins and signal vias. Secondary, controlled depth-drilling passes
remove all electro-deposited plating material in the PTH ensuring signal stubs are minimized.
Stubs are the source of impedance discontinuities and signal reflections, which become more
critical as data rates increase. Backdrilling can be performed from either side of the PCB and
to multiple depths. Drill sizes used for backdrilling are typically 6 to 10 mils larger than the
original tooling. Fabricators must be careful not to drill beyond (over drill) the calculated
depths as also not to under drill, leaving unacceptable stubs. Tradeoffs between signal quality
and manufacturing costs must be considered as well as the tradeoff between signal integrity
and board testability.

About the Author

Cadence PCB solutions is a complete front to back design tool to enable fast and efficient product creation. Cadence enables users accurately shorten design cycles to hand off to manufacturing through modern, IPC-2581 industry standard.

Follow on Linkedin Visit Website More Content by Cadence PCB Solutions
Previous Flipbook
Best Practices: Working with Design Partitions
Best Practices: Working with Design Partitions

Design Partitioning is a design environment promoting concurrent PCB design. The procedural steps and best ...

Next Article
Engineering Productivity and Design Reuse Tools for Effective PCB Design
Engineering Productivity and Design Reuse Tools for Effective PCB Design

You can drastically cut your design time down while at the same time reduce the chance for errors by utiliz...


Your Route to Design Success

First Name
Last Name
Opt-in to future emails and I understand I can unsubscribe at any time.
I agree to the terms of use
Terms of Use
Thank you!
Error - something went wrong!