Using the Manufacturing Stub Length Check & Analysis Portion of Backdrilling from within the Allegro

November 30, -0001
This video will demonstrate the advanced setup in specifying the manufacturing stub length option of the Backdrilling routine available from within the Allegro PCB Editor. This value is used to verify that the remaining stub length after backdrill is manufacturable
Previous Article
Solder Reflow Ovens: Solder Paste and PCB Assembly
Solder Reflow Ovens: Solder Paste and PCB Assembly

Your printed circuit board design will probably be assembled using a solder reflow oven. Here is some infor...

Next Video
Running the Setup and Analysis portion of Backdrilling from within the Allegro PCB Editor
Running the Setup and Analysis portion of Backdrilling from within the Allegro PCB Editor

This video will demonstrate the process of running the Setup and Analysis routine for Backdrilling from wit...

×

10 Common DFM Issues and How to Fix Them

First Name
Last Name
Location
State
Opt-in to future emails and I understand I can unsubscribe at any time.
I agree to the terms of use*
*required
Terms of Use
Thank you!
Error - something went wrong!