Cadence PCB Best Practices

Embedded Component Design Embedded Component Design October 2019 16 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. ❑ Adjacent signal layer set to Protruding allowed. This permits a component to cut across an adjacent signal layer as shown in the bitmap. Single Layer Mounted (Open Cavity) Components are placed on a single layer near the surface of the PCB. The cavities about the components are "open" allowing the components to extend beyond the surface layer. ❑ Embedded Status is set to Body up

• Cover
• Contents
• Embedded Component Design
• Introduction
• Licensing
• Terminology
• Front to Back Flow Considerations
• Drawing-Level Property Alternative
• Applying a Drawing-level Property
• Property List
• PCB Library Considerations
• Embedded Layer Setup
• Summary
• Adding Embedded Properties
• Embedded Component Parameters
• Direct Attach Method
• Indirect Attach Method
• Embedded Component Constraints
• Summary
• Embedded Geometry Subclasses
• Placement Applications
• Interactive Placement
• Quickplace
• Placement Edit Application Mode
• Cavities
• Reports
• Manufacturing Output
• SKILL