PCB 101: What are Blind and Buried Vias

May 31, 2019 Deepti Bankapur

 Sometimes, you can’t fit all your connections on one layer. This is where vias come to your rescue!   

Vias are barrel shaped vertical conductive holes that make connections between multiple layers of a PCB. The IPC defines eight different types of vias, but we’re going to talk about blind and buried vias; the two you’re most likely to work with.  

A blind via connects an outer layer of the board to inner layers and doesn’t go through the entire board. A buried via connects inner layers without reaching the outer layers. And a through hole via goes all the way through, from top to bottom, connecting all layers. 

 Vias

Source: EEVblog

Fitting More on Smaller Boards 

Blind and buried vias provide electrical connections from the outer layers to the inner layers as well as in between the inner layers, and are used when you have limited space on your PCB. Buried vias are hidden beneath the layers and free up surface space without impacting the traces or surface components on the top or bottom layers. Blind vias also free up space, can be essential for fine pitch BGA components and have the added benefit of helping reduce signal stubs through the drilling process as the via terminates at the last connected layer.   

You mostly see blind and buried vias in High density interconnect (HDI) PCBs. HDIs provide benefits such as increased layer density, improved power delivery and use of much smaller pitch devices. The hidden vias help keep the board light and compact. It is common to see blind and buried vias in electronic products like, cell phones, laptops, and medical devices to name a few. 

Incorporating blind and buried vias make more connections and higher board density possible. But not without drawback. Vias add extra steps to manufacturing and testing, which come with added costs.  

How Do They Make These Things? 

Vias are manufactured in two ways: either after or before multilayer lamination. When blind and buried vias are created, one or more of the cores are drilled and the through holes are plated. Then the stack is built and pressed. You can read more about the manufacturing process in the IPC-2221B manual. 

When creating blind vias, it is important to be aware of the drill depth. Depending on how shallow or deep the hole is, it could have a negative impact on the board. If the hole is too deep then it may cause signal distortion or degradation, and if it’s too shallow then it could result in an improper connection.   

It’s best to consult with your PCB manufacturer to get advice on the best approach to design your board to avoid a costly manufacture. Make sure to have your manufacturer plug the vias with either metal or thermal/electrical epoxy and plate copper over it; or else internal air bubbles can migrate upwards and lead to voids or pin holes in the solder joint. 

Blind and Buried Vias Within Layout 

You can easily configure your vias within the constraint manager in the physical workspace. Standard clearance rules apply when placing the vias. It is not recommended to place a via directly between pads of a surface mount component (SMD) as solder flux could potentially get trapped and cause corrosion problems. If solder flux would be under the SMD, inspecting and diagnosing the issue between a pad and via would be difficult once the board is manufactured and assembled. 

 

About the Author

Deepti Bankapur

Deepti Bankapur is the Chief Creative Content Ninja at Cadence PCB and has a background in Electrical and Computer Engineering. Besides tinkering with technology or DIY projects, she loves being outdoors and going on adventures.

More Content by Deepti Bankapur
Previous Article
PCB Routing Topologies Demystified
PCB Routing Topologies Demystified

Take your PCB routing topologies to the next level

Next Article
PCB 101: Include Teardrops in Your Designs to Save You Tears Later
PCB 101: Include Teardrops in Your Designs to Save You Tears Later

A teardrop is extra copper, straight or rounded, at the junction of a pad or via and a trace, or when a tra...