Issue link: https://resources.pcb.cadence.com/i/1514569
9. Within the Independent Sources window, select the Sine tab and leave the Voltage and Sine radio buttons that are selected as is. a. Enter the following values for the parameters as shown below – FREQ = 50, VAMPL = 2, and VOFF = 1, AC = 0, and click Place. The VSIN symbol is now attached to your mouse cursor. Move your cursor to the correct position on the schematic page and click to place the part. 10. Either press Escape (Esc) on your keyboard or right-click and select End Mode to avoid placing the part again. 11. Next, place the rest of the parts needed by clicking on Place – PSpice Part. Select Diode, Resistor, Capacitor, and Ground. For each part, move the cursor to the correct position on the schematic page, rotate if necessary, click to place, and press Escape. Note: To rotate the part so the arrows are pointing in the correct direction, press R one or more times to rotate the part to the desired orientation. If you need to rotate the part after it has been placed, just select it and press R. 8 www.cadence.com Getting Started With PSpice