Issue link: https://resources.pcb.cadence.com/i/1514569
Evaluating Circuit Behavior Using Probes Note: It is important to place voltage, current or power probes ( ) on your circuit before simulating as they act as measurement points, allowing PSpice to capture and display waveforms associated at those nodes. 5. Add a voltage probe to your circuit to see the voltage level across the resistor as shown below: 6. From the toolbar menu, choose Run ( ). PSpice simulates the circuit and calculates the time domain information. 7. If there are no connection errors in your schematic, the session log at the bottom will let you know if the PSpice netlist was generated. 8. Once the simulation is completed, the following voltage waveform will be displayed as shown below: 13 www.cadence.com Getting Started With PSpice