Issue link: https://resources.pcb.cadence.com/i/1180268
Working with IDF Pro/Engineer Configuration Settings October 2019 30 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. ecad_create_hint_add Helps create an ecad_hint.map file. Yes automatically renames components, if necessary, each time the library of component outlines is imported to Pro/ENGINEER. This does not create an ecad_hint.map file. It controls whether the ecad_hint.add file is created. ecad_default_comp_height Sets the default value and units for an ECAD component being imported. Units can be: inch, mil (1E-3 inches), thou (1E-6 inches), cm, mm, micron (1E-6 meters), dsu (1E-8 meters). If not set, the system uses the current component's units. ecad_default_comp_place_status Sets the default component placement status for export (parameter setting overrides the default). ecad_export_holes_as_cuts Exports Pro/ENGINEER holes as cuts to ECAD systems. ecad_exp_both_two_areas Supports the export of ECAD areas with different "Above Board" and "Below Board" conditions. Yes enables you to export both sided keepin and keep-out ECAD areas as two individual areas (top and bottom). ecad_import_holes_as_features Imports sections specified as DRILLED_HOLE as through-all holes. Boards created with Pro/ ENGINEER drilled holes export with the default value of NPTH for the ECAD_HOLE_TYPE parameter. Create this feature parameter if a value of PTH is needed (IDF 2.0/3.0). ecad_mapping_file Specifies the ecad_hint.map file that will be used for ECAD operations. ecad_other_outl_csys_def_name Specifies the default coordinate system name for the OTHER_OUTLINE section of an IDF 2.0 ECAD component being imported. If you do set this variable, the system prompts you for a name. ecad_panel_csys_def_name Specifies the default coordinate system name added to an ECAD panel being imported. If you do not set this variable, the system prompts you for a name. Table A-1 Pro/ENGINEER Variables Pro/ENGINEER Environment Variable Description