Running the Setup and Analysis portion of Backdrilling from within the Allegro PCB Editor

November 30, -0001
This video will demonstrate the process of running the Setup and Analysis routine for Backdrilling from within the Allegro PCB Editor. Both manually creating backdrill pairs and using the Analysis section to create backdrill pairs will be shown
Previous Video
Using the Manufacturing Stub Length Check & Analysis Portion of Backdrilling from within the Allegro
Using the Manufacturing Stub Length Check & Analysis Portion of Backdrilling from within the Allegro

This video will demonstrate the advanced setup in specifying the manufacturing stub length option of the Ba...

Next Video
Entering and Updating Packstack Data to support Backdrilling from within the Allegro PCB Editor
Entering and Updating Packstack Data to support Backdrilling from within the Allegro PCB Editor

This video will demonstrate adding the required data in a padstack using the Pad Editor to support the back...

×

Your Route to Design Success

First Name
Last Name
Location
State
Opt-in to future emails and I understand I can unsubscribe at any time.
I agree to the terms of use
*required
Terms of Use
Thank you!
Error - something went wrong!