Cadence PCB Best Practices

Working with Real-Time DFA Analysis

Issue link: https://resources.pcb.cadence.com/i/1180266

Contents of this Issue

Navigation

Page 25 of 28

Working with Design Partitions Design Partitioning October 2019 26 Product Version 17.4-2019 © 1999-2019 All Rights Reserved. Note: During recovery, no pin/gate swaps nor schedule updates are imported. If component assignments fail, then the symbol becomes unplaced. 5. If the recovery is successful, save the drawing. 6. If not, import the file that was exported in Step 1, or quit the drawing to return the drawing to the previous state. Figure 1-11 Recovery Mode: Location Cell Must Be In Red Frequently Asked Questions Q: Can partition designers work in sections other than their own partition? A: Yes, provided the Soft_Boundary option is enabled. Otherwise Partition designers are limited to working within their partition boundary. Q: Can partition designers work within the same partition but on different layers? A: Yes, this requires the Workflow Manager to be setup for horizontal partitions. Q: When using the partition editor, can I place components outside my partition? A: Yes, provided the Soft_Boundary option is enabled by the master designer. Q: Why are there two models for creating partition areas?

Articles in this issue

view archives of Cadence PCB Best Practices - Working with Real-Time DFA Analysis