OrCAD X Resources

4. Set your 3D clearances and other parameters as shown below, then click Ok. 5. You can set your values even after placing the constraints. 6. Now you can apply the constraint set by choosing the 3D > 3D Clearance > Design > Component to Rigid-Flex worksheet. 4 4 www.cadence.com OrCAD X Constraint Management Guide

• Cover
• Part 2 - Standard Constraints
• Physical and Spacing Constraints
• Trace Width: Minimum and Maximum Width for Signal And Power Traces.
• Via Size: Diameter and pad size for vias, including microvias and blind/buried vias.
• Differential Pairs (Basic Setup)
• Creating a Diff Pair
• Spacing Constraints
• Creepage and Clearance: Minimum Distances Between Conductive Elements to Prevent Electrical Arcing
• Component Spacing: Minimum Distances Between Components to Avoid Interference and Facilitate Cooling
• Manufacturing Constraints
• Fabrication Tolerances: Allowable Variations in Dimensions for Manufacturing
• Board Outline Dimensions: Tolerances for Overall Board Size and Shape
• Trace Width for Manufacturing: Minimum Copper Width for Traces
• Trace Spacing: Minimum Distance Between Copper Features
• Annular Ring: Minimum Width of Copper Surrounding a Hole
• Drill to Copper Spacing
• Teardrops (Fillets)
• Pad To Mounting Hole Spacing: Minimum Distance Between Pads and Mounting Holes
• Acid Traps: Avoiding Acute Angles in Copper Features That Can Trap Etching Chemicals
• Minimum Copper Area: Smallest Allowable Area of Isolated Copper Features
• Assembly Constraints: Rules for Component Placement, Orientation, and Soldering
• Outlines and Cut Outs
• Where to Apply the Constraint Set
• Package to Package Spacing
• Component Spacing to PCB Features
• Pastemask
• Silkscreen and Solder Mask: Specifications for Text and Mask Application on The PCB.
• Design for Test (DFT) Constraints
• Test Points: Placement and Minimum Distances From Other Test Points and Components
• 3D Constraints
• Rigid Flex PCB Constraints
• Teardrops (Fillets)
• Component to Flex PCB
• Conclusion