Building Differentiated Products Through Shorter, More Predictable Design Cycles

October 18, 2018 Cadence PCB Solutions

Share this Flipbook
Facebook
Twitter
Email
LinkedIn

To position themselves for growth in today’s market, systems companies need to build highly
differentiated products; reduce time to market; and focus on compliant, environmentally aware
designs. This paper addresses the first two challenges—the needs to build differentiated products
and reduce time to market. It discusses new design techniques, processes, and methodologies that
can reduce design cycles by as much as 40%.

About the Author

Cadence PCB solutions is a complete front to back design tool to enable fast and efficient product creation. Cadence enables users accurately shorten design cycles to hand off to manufacturing through modern, IPC-2581 industry standard.
Follow on Linkedin Visit Website More Content by Cadence PCB Solutions

Previous Flipbook

3D ICs with TSVs - Design Challenges and Requirements

3D ICs promise “more than Moore” integration by packing a great deal of functionality into small form facto...

Next Flipbook

Power-Aware Analysis Solution

Other content in this Stream

Tech Clarity - Managing Work in Progress in Electrical Design

Building Differentiated Products Through Shorter, More Predictable Design Cycles

About the Author

Previous Flipbook

Next Flipbook

Other content in this Stream

EDM creates the opportunity to help manage the overall electrical design process in addition to helping individual designers and managing design processes. Centrally aggregated WIP designs contain...

As the transferring rate increase, Power Integrity becomes a more and more critical issue in modern high speed design.

Typically simultaneous switching noise (SSN) transient simulations require significant CPU and RAM resources.

Power and ground planes in a printed circuit board may connect to the power supply at several locations. Moreover, a number of decoupling capacitors may be connected to the power and ground planes.

This paper investigates the timing skew problem on high speed, high-definition multimedia interface (HDMI) channel due to the fiber weave effect of Printed circuit board (PCB).

Standard IBIS-AMI models can be used for modeling repeaters. No additional change in IBIS-AMI expression

This paper will suggest methodologies for creating a “virtual prototype” of your serial link pre-design, and how to create the associated interconnect and SerDes models that go with it.

Ultra-low impedance measurement and proper embedded technique should be applied to obtain the good correlation

This paper presents full-wave electromagnetic field simulations on the effects of shorting via arrays for the reduction of power and ground noise in IC packages.

Transistor-level accuracy can be obtained with high capacity channel simulation to predict BER using AMI modeling, even for the most complex EQ architectures

The electrical characteristics of the power and ground supply of a PC microprocessor packaged in a Ball Grid Array (BGA) package mounted on a card are studied by dynamic electromagnetic field analysis

The focus of this paper is the low frequency portion, including DC, of the spectrum for broadband Sparameters and guidelines to support successful SSO analysis for Chip-Package Board systems.

This paper presents a proof-of-concept analysis that was performed to test the hypothesis that a typical printed circuit board (PCB) and package power distribution system (PDS)

AMI models using AMI_GetWave call are incompatible with purely statistical techniques

A practical approach for accurately modeling high-speed link structures is presented and named as the “cut and stitch” (C&S) methodology.

End users require ready access to accurate package models with increasingly complex packages, detailed PI consideration, and higher bandwidth

The effects of the distribution of power and ground vias in C4/BGA type of packages are studied.

Panel session addressing high-speed channel design challenges

Simulation / Measurement correlation requires accurate modeling of TX/RX/Channel