Enabling CM on Existing Schematic Design with Constraint Added in PCB Layout: RAK
Learn more at Cadence Support Portal - https://support.cadence.com
© 2019 Cadence Design Systems, Inc. All rights reserved w orldw ide. Page 28
Figure 34: Migration summary
4. The Board will get updated in PCB Editor.
5. Click on the CM icon in PCB Editor to invoke CM.
6. Cross-check the constraints defined in the previous modules:
• Module 3: The 'No Rats' property for Power Nets
• Module 4: The MG1_CAN match group
• Module 5: Pin pairs for the K-LINE net
• Module 6: ECSet from the DAC_CLOCK SigXplorer
Support
Cadence Support Portal provides access to support resources, including an extensive
knowledge base, access to software updates for Cadence products, and the ability to
interact with Cadence Customer Support. Visit https://support.cadence.com.
Feedback
Email comments, questions, and suggestions to content_feedback@cadence.com.
